Cp regulator manual

Manuals Parts Find replacement parts and get the most from your Miller products by downloading the specific Owner's Manual for your unit. From safety precautions, operations/setup information, and maintenance to troubleshooting and parts lists, Miller's manuals provide detailed answers to your product www.doorway.rug: cp regulator. The CP II Regulator without a proportional valve is controlled by a manually adjusted air pressure regulator. The CP II Regulator with a proportional valve is controlled by an electrically adjusted voltage to the pressure regulator. Eaton's Cooper Power series Voltage Regulator. Read this manual first Read and understand the contents of this manual and follow all locally approved procedures and safety practices before installing or operating this equipment. Read and understand the manual detailing the installation and operation of the regulator used with this control.

controller blocks PID_CP and PID_ES. •The product "Standard PID Control Tool" consists essentially of the tools for configuring the controller blocks. This product is referred to simply as "configuration tool" in this manual. •This manual is a separate product and describes both the product "Standard. Typical CP Regulator Cut-away View Introduction The CP Series pressure loaded regulators have been engineered to fit a multitude of pressure-reducing applications including light industrial and commercial installations, which include accurate control for use in pressure-factor measurement (fixed factor billing) applications. CP/CPF Series Valve Installation and Operation BODY INLET FLOW CONTROL (select models) OUTLET SOLENOID BLEED SCREW Before Installation llInstall master valves, pressure regulators and back - flow preventers as needed. llA pressure regulator is required if water pressure A Manual on: Turn the solenoid counter-clockwise 1/4 turn. Do not.

E Test wiring by using the Manual Water feature on the irrigation controller. F Adjust the flow control to reduce over-spray. (select models). 1 3 2 Operating Ranges CP / CPF CP / CPF Flow2 - 22 GPM - 40 GPM Pressure 15 - PSI 15 - PSI blNOTE: For flows below 3 GPM ( m3/h), or any drip application, use a AUTO/OFF/MANUAL switch to its OFF position before working on equipment and remove the 15A fuse from the generator control panel. In case of accident caused by electric shock, imme-diately shut down the source of electrical power. If this is not possible, attempt to free the victim from the live conductor. AVOID DIRECT CONTACT WITH THE VICTIM. be used to simplify substation installation of regulators requir-ing a specific live part-to-ground clearance. The regulator control can be mounted on the regulator tank, or at a point remote from the unit. Rubber-covered cable is available in lengths of 15, 20, 25, 30, and 35 ft for intercon-nection between the control and the regulator.